The only Australian made T7 wheel spanner
This tool is designed to be used on the Tenere 700 (T7) however could be suitable for other bikes.
This tool allows you to undo the hex on the front axle as well as undo the recessed nut on the rear axle. It is well made and is coated in gold colour to provide a long-lasting protection.
Please note - to avoid damage to the tool it must only be used by hand. Do not stand on the tool or hit it with a hammer etc. The best way to prepare your bike for use with this tool is to back off both the front and rear axles using standard workshop tools and then tightening both axles up using your hand strength only with this tool as tight as you can. Don't forget to nip the pinch bolts back up on the front axle.
Postage for this item is $12.50 on its own but if purchased with another item that also attracts a postage fee the $12.50 can be taken from the order cost.
